![]() I have BIAS AMP PRO, BIAS AMP 2 LE and BIAS FX PRO. Here's four examples of why I hate Positive Grid. There's no way, in Command Center, to have a single FS send more than one PC#. You can also set the Footswitches to send SPECIFIC PC#s or, if the BIAS HEAD allows it, whatever CC# (Control Change) it needs for Preset Previous/Next. When you load a Preset in HXFX, you can have each Snapshot set to send a different PC#, thus changing the Preset on the BIAS HEAD. ![]() When you load a Preset or change Snapshots within a Preset, the Instant Commands (lightning bolts) are sent to the external device (BIAS HEAD). If You have a link to the BIAS HEAD Manual (I'm not sure it exists) or the BIAS AMP SW Manual (I had a link, but it no longer works), I might be able to help you more, but otherwise all I can do is tell you how MIDI and Command Center work with PC#s.įor starters, you're mis-using the term BANK. Years after I decided that I hate Positive Grid, they still have one of the world's worst web sites. IIRC, when using BIAS SW, you do this by assigning a Program Change Number (PC#) to the Preset.Īgain IIRC, the BIAS HEAD is configured using the BIAS AMP SW. What you're actually changing is the BIAS PRESET. ![]() write to me like you're explaining it to an idiot.Īs I understand the way the BIAS Head works, there's only one "Channel" in the traditional sense. keep in mind if you answer I still don't really understand how the snapshots work ect. Like I said I'm super new, I've had this peddle 2 hours now just trying to program this simple (or I would think it would be simple) thing. I'm new to this and all I can figure is I have to waste to switches instead of just having an on and off effect on one. Ive managed to program a lighting bolt of instant whatever you're supposed to call it, to automatically go to one channel when I enter a bank, and I programmed a foot switch to change the channel, but once I click the foot switch a second time, it doesn't revert to the original channel. I want to program a bank to have a switch that sends a PC signal to the amp head to change to one channel when pressed, and go to another channel when not pressed.Īnd I can t seem to figure out how to do this. currently I have it hooked up into the fx loop of my Bias head Here's my situation, I have an HX effects not the full helix in case that matters. I'm really having difficulty with figuring out exactly what I'm doing with this thing
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |